Software

Now you have your NodeMCU connected to your lights, you need to setup a development enviroment. DirtyWatts MicroIndicator uses a tool called PlatformIO to handle uploading the C++ code to the NodeMCU.

To setup your windows/macos/linux device for development:

1. Download and install Git if you don't have it already.
2. Download and install Visual Studio Code (VS Code) if you don't have it already.
3. Open VS Code and install the PlatformIO extension.
4. Download and extract the DirtyWatts codebase from Questionable-Research-Labs/DirtyWatts.
   

   

   
   
5. Open the DirtyWatts/MicroIndicator folder: 

   

    

You are now ready to start making changes!

Make changes to fit your device

In src/config.h file, there is some configuration options you might need to change:

#pragma once


#ifdef OUTPUT_NEOPIXEL
    #define NeoPixelPin D1 // D1 on esp8266
    #define NeoPixelCount 30
#endif

#define APIRequestInterval 2000	 // 20 seconds

#define ApiErrorColour 150, 150, 255  // Light Blue

In particular, if you plugged your lights into a diffrent pin than D1, then you need to change it here. You also need to set the number of LED's you have connected. To set this, count every single one, and change the #define NeoPixelCount 30 to #define NeoPixelCount <numberOfLEDs>.

Here, you can also change the color shown when it can't connect to the Dirtywatts Servers and change how often it polls new data.

Upload the code

First, you want to check that PlatformIO can see the device. Plug in your NodeMCU via a microUSB cable into your computer and hopefully it will automatically be picked up by your computer.

If it doesn't show here, then your NodeMCU being detected/recognised by your computer. First thing to check is trying a new USB cable and port, it needs to be able to carry data which quite a few of the cheap cables can't. You might need to install a driver, so check the bottom of your NodeMCU to see if it wants you to install a driver for a 'CH304g', 'CP2021', etc. As a last step, you can also try reflashing the firmeware.

If it shows up, great! Let's upload and monitor the result using the PROJECT TASKS pannel, expand the correct compile target according to the following table:

Development Board Name	Compile Target
ESP8266 ESP-12 NodeMCU (v0.9)	nodemcu-neo
ESP8266 ESP-12E NodeMCU (v2)	nodemcuv2-neo
ESP8266 ESP-12E NodeMCU (v3)	nodemcuv2-neo
ESP32 Development Board	esp32-neo

If you are not sure, you can always try them all! It won't pernemently brick your board, but it will fail to upload with possibly weird errors.

When you are ready, run the "Upload and Monitor" task.task and hopefully it will start uploading!

Now, it's onto configuring your device!